Filter
Top Products
Installation
8
5. Plug the adapter into a standard AC outlet.
6. Lift the base’s antenna to a vertical position.
1P"C"9CNN"2NCVG"QT"9CNN
To mount the phone directly on a wall, you need two
screws (not supplied) with heads that fit into the
keyhole slots on the base. Drill two holes 3
15
/
16
inches apart. Thread a screw into each hole,
leaving the heads extended about
1
/
8
inch.
1. Plug one end of the supplied modular cord
(short for a wall plate, long for direct wall
mounting) into the
TEL LINE
jack on the base’s
back.
2. Insert the supplied AC adapter’s barrel plug
into the
DC IN 9V
jack.
3. Route the adapter and modular cords through
the base’s grooves.
4.
For a wall plate
, plug the modular cord’s other
end into the wall plate jack, then align the
base’s keyhole slots with the wall plate studs
and slide the base downward to secure it.
For direct wall mounting
, align the base’s
keyhole slots with the mounting screws and
slide the base downward to secure it.
5. Plug the adapter into a standard AC outlet.
6. Lift the base’s antenna to a vertical position.
+056#..+0)"6*'"%*#4)+0)"
%4#&.'
1. Insert the supplied AC adapter’s barrel plug
into the DC IN 9V jack on the back of the
charger.
2. Route the cord through the strain relief slot and
plug the adapter into a standard AC outlet.
TEL LINE
DC IN 9V
DC IN 9V