Filter
Top Products
Installation
11
display. The handset charged in the cradle must
also be registered with the base prior to use.
Place the second handset on the base. The base’s
CHARGE LED flashes. When the registration is
complete
>I(
>I(>I(
>I(
appears in the second handset’s
display.
±
5'66+0)"6*'"&+#.+0)"/1&'
Your phone comes set for tone dialing. If you have
pulse service, you need to change the dialing mode.
If you are not sure which type of service you have,
do this test:
1. Lift the handset, press
TALK/FLASH
, and listen
for a dial tone.
2. Press any number other than
0
or, if required,
an outside line access code (9, for example).
If the dial tone stops,
you have touch-tone
service.
If the dial tone continues
, you have pulse
service.
Once you have determined which type of service
you have, set the dialing mode. Use handset HS1 to
set the dialing mode.
±
1. Press
END
to hang up the phone if necessary,
then hold down
CID/MENU
until the selection
screen appears.
2. Press 4 or
9
three times to select
:_Wb
:_Wb:_Wb
:_Wb
.
3. Press
CH/SEL
to toggle between
Jed[ý
Jed[ýJed[ý
Jed[ý
and
Fkbi[
Fkbi[Fkbi[
Fkbi[
.
±ý
4. To store the new setting, press
END
, and return
the handset to the base.
±
"016'"
±
"
Registering the Second
Handset
• Once registered, you
may charge HS1 and
HS2 on either the base
or the charging cradle.
• When a power failure
occurs, or the base
unit’s power is
disconnected for longer
than one hour, both
handsets will need to be
re-registered.
Setting the Dialing Mode
• You cannot use HS2 to
set the dialing mode.
Check the handsets’
displays to distinguish
between HS1 and HS2.
• The phone exits setting
mode if a call or page is
received, or if you press
END.