Filter
Top Products
Installation
13
5'66+0)"#761"6#.-
Your phone is preset so you must press
TALK/
FLASH
to answer a call. With Auto Talk turned on,
you can answer a call by just lifting the handset
from the baseor cradle. Auto Talk is independent in
each handset. You can set each handset differently.
1. Lift the handset and hold down
CID/MENU
until
the setup menu appears.
2. Press
CH/SEL
to change the Auto Talk setting.
Ed
EdEd
Ed
or
E\\
E\\E\\
E\\
appears.
3. To clear the screen when you finish, press
END
or return the handset to the base or cradle.
6740+0)"%#..'4"+&1%#.."
9#+6+0)"1011((
If you have Call Waiting and Caller ID service, you
can set the system to show Caller ID information for
an incoming call even while you are on the phone.
1. Lift the handset and hold down
CID/MENU
until
the menu appears.
±
2. Press
2
or
9
99
9
to select
9?:9Mý
9?:9Mý9?:9Mý
9?:9Mý
(Caller ID/Call
Waiting).
3. Press
CH/SEL
to change the Caller ID/Call
Waiting setting.
Ed
EdEd
Ed
or
E\\
E\\E\\
E\\
appears.
4. Press
END
and return the handset to the base
to store the new setting.
5614+0)";174 "#4'#"%1&'
You can store your local area code in the phone’s
Caller ID record so the area code does not appear if
the received call is from your local area. If for some
reason you need to dial the area code (or store it in
memory), you can add it afterwards. See “Adding/
Deleting the Area Code” on Page 24.
±ý
±
"016'"
±
"
Turning Caller ID/Call
Waiting On/Off
This setting must be made
from HS1. The CIDCW
menu does not appear on
HS2.
Storing Your Area Code
• If your calling area
requires 10-digit dialing
(including area code), do
not enter the area code.
• The area code setting is
independent in each
handset. You can set
either handset to a
different area code.