Filter
Top Products
Setting the Dialing Mode
9
3. Plug the battery pack’s connector into the socket in the
compartment, (the connector fits only one way), replace
the battery pack, and replace the cover.
To charge the battery pack, place the handset either face-
up or face-down on the base.
The CHARGE indicator on the base lights and the number
of new and total Caller ID records for each line appears on
the handset's display. Be sure the battery pack is properly
connected before you try to charge it. The CHARGE
indicator lights when the handset is on the base even if the
battery pack is not properly connected
.
Recharge the battery pack when
Bemý8Wjj[ho
Bemý8Wjj[hoBemý8Wjj[ho
Bemý8Wjj[ho
flashes.
When you first use the phone after charging or recharging
the battery pack, the phone might not work and you might
hear a beep when you press
LINE 1
or
LINE 2
. Return the
handset to the base for about five seconds to reset the
security access-protection code.
The supplied battery pack should last about a year. If the
battery pack does not hold a charge for more than 2 hours
after an overnight charge, replace it with a new 3.6-volt, 600
mAh battery pack with a connector that fits the socket in the
battery compartment.
You can order a replacement battery pack through
RadioShack. Install the new battery pack and charge it for
about 15–20 hours.
R
If you have trouble replacing the battery pack, take the
phone to RadioShack for assistance.
#
5'66+0)"6*'"&+#.+0)"/1&'
Your phone comes set for tone dialing. If you have pulse
service, you must change the dialing mode. If you are not
sure which type of service you have, do this test.
1. Press
LINE 1
or
LINE 2
and listen for a dial tone.
2. Press any number other than 0.
±
If the dial tone stops, you have touch-tone service. If the dial
tone continues, you have pulse service.
To set the dialing mode, press the line button to hang up the
phone if necessary. Hold down
FLASH
on the base keypad
until the phone beeps, then press
#
for pulse dialing or
*
for
tone dialing. The phone beeps.
R
"9#40+0)
ýR
ý
R
"
Dispose of the old battery pack
promptly and properly. Do not
burn or bury it (see “Battery Safety
Instructions+” on Page 5).
#
"+/2146#06"
#
The EPA certified
RBRC® Battery
Recycling Seal on the
nickel-cadmium (Ni-Cd)
battery indicates
RadioShack is voluntarily
participating in an industry program
to collect and recycle these
batteries at the end of their useful
life, when taken out of service in the
United States or Canada. The
RBRC program provides a
convenient alternative to placing
used Ni-Cd batteries into the trash
or the municipal waste stream,
which may be illegal in your area.
Please call 1-800-THE-SHACK (1-
800-843-7422) for information on
Ni-Cd battery recycling and
disposal bans/restrictions in your
area. RadioShack’s involvement in
this program is part of the
company’s commitment to
preserving our environment and
conserving our natural resources.
±
"016'"
±
"
• If your phone system requires
that you dial an access code (9,
for example) before you dial an
outside number, do not press
the access code either.
• The phone exits setting mode if
a call is received, or if you press
either line button.