Filter
Top Products
Installation
8
5.
To mount the
phone on a wall
plate
, plug the
other end of the
short modular
cord into the
wall plate jack,
then align the
bracket’s
keyhole slots
with the wall
plate studs and
slide the base
downward to secure it. If you are using two phone
cords, plug the second cord into the second phone
jack.
To mount the
phone directly on a
wall
, align the
bracket's keyhole
slots with the
mounted screws
and slide the base
downward to
secure it. Connect
the phone cord(s)
to the modular
phone line jack(s).
6. Plug the adapter
into a standard AC
outlet.
7. Press and lift out the handset holder, flip it over, then
snap it back into place to hold the handset.
8. Raise the base’s antenna to a vertical position.
%100'%6+0) "#0&"%*#4)+0)"6*'"
$
#66'4;"2#%-
The phone comes with a rechargeable nickel-cadmium (Ni-
Cd) battery pack in the handset. Before using your phone,
you must connect the battery pack, then charge it for about
15–20 hours.
±
1. Press down and slide off the battery pack compartment
cover.
2. Lift the battery pack out of the compartment.
DC IN 9V
TEL LINE 2
TEL LINE 1 / 2
±
"016'"
±
"
• If the base loses power for 60
minutes while the handset is
away from it, the security code
might be lost. To reset the code,
return the handset to the base
for about five seconds.
• Using a pencil eraser, clean the
charging contacts on the
handset and base about once a
month.
• If the battery pack becomes
weak during a call, the handset
beeps every three seconds and
Bemý8Wjj[ho
Bemý8Wjj[hoBemý8Wjj[ho
Bemý8Wjj[ho flashes. When this
happens, you cannot make a
call until you recharge the
battery pack.
• About once a month, fully
discharge the battery by
keeping the handset off the
base until
Bemý8Wjj[ho
Bemý8Wjj[hoBemý8Wjj[ho
Bemý8Wjj[ho flashes.
Otherwise, the battery pack
loses its ability to fully
recharge.
• If the display is blank and the
phone does not work, recharge
the battery pack. (The battery
power might be too low to light
the display.)
• If you are not going to use your
phone for an extended period of
time, disconnect the battery
pack. This increases the battery
pack's usable life.