Filter
Top Products
Installation
7
10"#"9#.."14"9#.."2.#6'
To mount the base directly on the wall, you need two screws
(not supplied) with heads that fit into the keyhole slots on
the bottom of the bracket. Drill two holes 3
15
/
16
inches apart.
Then thread a screw into each hole, letting the heads
extend about
5
/
32
inch from the wall.
1. Insert the two tabs
at the top of the
narrow end of the
supplied bracket
into the base’s
upper tab slots,
then press down
on the bracket's
latches and insert
them into the clip
slots.
2.
To connect the phone to a two-line phone jack
, plug
one end of the supplied long modular cord into the
TEL LINE 1/2
jack on the back of the phone.
±
To connect the phone to two one-line phone jacks
, plug
one end of the supplied short two-line modular cord into
TEL LINE 1/2
and plug another cord (not supplied) into
the
TEL LINE 2
jack.
To connect the phone to a single one-line phone jack
,
plug one end of the supplied long modular cord into the
TEL LINE 1/2
or
TEL LINE 2
jack.
3. Insert the supplied AC adapter’s barrel plug into the
DC IN 9V
jack on the back of the base.
4. Route the adapter’s
cord through the
narrow groove on the
bracket. If you are
using two phone cords,
route the second cord
through one of the
wide grooves on the
bracket.
±
"016'"
±
"
If you connect the phone to a two-
line phone jack with a two-line
cord, do not connect a cord to the
TEL LINE 2 jack or the phone will
not operate properly.