Filter
Top Products
Installation
9
Your telephone connects directly to a
modular telephone line jack. If your
telephone wiring does not have a modular
jack, you can update the wiring yourself
using jacks and adapters (available at your
local RadioShack store), or have the
telephone company update the wiring for
you. You must use compatible modular
jacks that are compliant with Part 68 of FCC
Rules. Ô
On a Desk Top
1. Plug one end of the supplied long
modular cord into the
TEL LINE jack on
the back of the base.
2. Plug the modular cord’s other end into
a modular phone line jack.
3. Insert the supplied AC adapter’s barrel
plug into the DC IN 9V jack on the back
of the base.
4. Route the adapter’s cord through the
strain relief slot on the base, then plug
the adapter into a standard AC outlet.
On a Wall Plate or Wall
To mount the phone directly on a wall, you
need two screws (not supplied) with heads
that fit into the keyhole slots on the base.
Drill two holes 3
15
/
16
inches apart. Thread a
screw into each hole, letting the heads
extend about
1
/
8
inch.
1. Make the AC adapter and the short
telephone line cord through the hole on
the bracket.
2. Slide the bracket into the notches on
the base.
3. Plug the adapter into a standard AC
outlet. Hook the cord on the notch of
the bracket.
Ô NOTE Ô
The USOC number of the
jack to be installed is
RJ11C (or RJ11W for a wall
plate jack).
CAUTION
You must use
a Class 2
power source
that supplies 9V DC and
delivers at least 400 mA.
Its center tip must be set
to positive and its plug
must fit the phone’s DC
IN 9V jack. The supplied
adapter meets these
specifications. Using an
adapter that does not
meet these
specifications could
damage the phone or
the adapter.
!