Filter
Top Products
Setting Menu Options
26
• If you are not sure of your dialing
system, set the unit to tone dialing.
Make a trial call. If the call connects,
leave the setting as is; otherwise set
the unit to pulse dialing.
• If your phone system requires pulse
dialing and you need to send DTMF
tones in certain situations during a call,
you may switch over to tone dialing
(refer to “Tone Dialing Switch Over” on
page 32).
1. Press the
MENU soft key. Select the
Global Setup menu, and then the Dial
Mode submenu.
2. Press
VOL/RING/ or VOL/RING/ to
select
Tone or Pulse (the initial
setting is Tone).
3. Press the OK soft key. You will hear a
confirmation tone.
De-register the Handset
Deregister HS clears the handset’s ID from
the main base unit and the base ID from the
handset. You will usually only deregister the
handset if you are having a problem with
your phone.
1. In standby mode, select Deregister HS
in the menu and press the
OK soft key.
Deregister HS? appears.
2. Press VOL/RING/ or VOL/RING/ to
select
Yes and then the OK soft key.
When de-registration is complete you
will hear a confirmation tone, and
Deregistration Complete
appears.
3. After de-registering the handset, place
the handset to the base to register. You
must re-register the handset before you
can use it.