Filter
Top Products
The Integrated Answering Device
57
2. Press SKIP/SELECT or
REPEAT/SELECT until the desired
message record time appears.
3. Press
SET to select the new recording
time.
A confirmation tone sounds, the system
announces the new record time.
Announce only feature
The Announce only feature plays a pre-
recorded outgoing message or your own
personal outgoing message, but it will not
allow the caller to leave a message. To set
“Announce only”, follow the steps on page
56. To choose between the pre-recorded
message or your own personal greeting,
press
OGM, when the outgoing message is
played. Press OGM to select the greeting of
your choice.
If you want to use your own greeting, you
may want to change your greeting to omit
the prompt to leave a message. Refer to
“Recording a personal outgoing message
(Greeting)” on page 53.
The following message is pre-recorded:
“Hello, no one is available to take your call.
Please call again.”
Setting the message alert
Message Alert feature lets you know when
you have a new incoming message by
sounding a short alert tone.
If you set the Message Alert On, and when
a new message is received, the alert tone
will sound every 15 seconds. Set the
Message Alert to On or Off by using
CLOCK/MENU.
1. Press
CLOCK/MENU five times. The
current setting ( or ) appears on
the base and it is announced.