Filter
Top Products
67
Before using your telephone equipment, you should always follow basic safety instruc
-
tion to reduce the risk of fire, electrical shock and injury to
persons, and damage to
property.
1. Read and understand all instructions
2. Follow all warnings and instructions including those marked on
the product
3. Unplug this product before cleaning. Do not use liquid cleaners
or aerosol cleaners.
Use damp cloth for cleaning
4. Do not install the telephone equipment in the bathroom or near a wash bowl,
kitchen sink,
or laundry tub, in a wet basement, or near a swimming pool
5. Slots or openings in the equipment are provided
for ventilation to protect it from
over-heating. These openings must not be blocked or covered.
6. The product should be operated only from the type of power source indicated on
the instructions.
If you are not sure of the type of power supply, consult your
dealer or local power company.
7. Do not overload wall outlets and extension cords as th
is can result in fire or electri-
cal shock.
8. Never push objects of any kind into this product
through cabinet slots as they may
touch dangerous voltage points or short out parts that could result in fire, electrical
shock, or injury. Never spill liquid of any kind into this product.
9. To reduce the risk of electrical shock or burn
s, do not disassemble this product.
Opening or removing covers may expose you to dangerous voltages, dangerous
electrical current, or other risks. Incorrect reassemble can cause electrical shock
when the appliance is subsequently used. If the product need repair, consult your
dealer.
10. Refer servicing to qualified service personnel.
11. Avoid using telephone during an electrical storm. There may be
a risk of electrical
shock from lightning.
12. Do not use the telephone to report a gas leak in
the vicinity of the leak.
13. Do not place the base or charger near micr
owave ovens, radio equipment, or
non-ground connected televisions.
These appliances may cause electrical interference to the base or handset
14. The charger must be placed on a hard, flat surface and connected to
a functional
120 volt AC power source depending on the country of use.
The WEEE Marking on this equipment indicates that the
product must not be disposed of with unsorted waste,
but must be collected separately.