Filter
Top Products
Programmable Settings
46 For assistance, please visit http://www.panasonic.com/phonehelp
Setting telephone line Y ^
Line selection
The line selection mode determines which
line is selected when you press {C} on
the handset or {SP-PHONE} on the base
unit.
–“Auto”: When making a call, line 1 is
selected. If that line is unavailable, line 2
is selected. When answering a call, the
ringing line is selected.
–“Line1”: Line 1 is selected.
–“Line2”: Line 2 is selected.
1 {MENU} (center of joystick) i h i
{SELECT}
2 “Set tel line” i {SELECT}
3 “Line select” i {SELECT}
4 Select the desired setting. (Default:
“Auto”) i {SAVE} i {OFF}
Note:
LYou can select a line manually
regardless of the line selection mode by
pressing {LINE1} or {LINE2}.
1 {MENU} i h i {SET}
2 “Set tel line” i {SET}
3 “Line select” i {SET}
4 Select the desired setting. (Default:
“Auto”) i {SET} i {STOP}
Note:
LYou can select a line manually
regardless of the line selection mode by
pressing {LINE1} or {LINE2}.
Flash time
The flash time depends on your telephone
exchange or host PBX.
LYou only need to program this setting
once, using either the handset or base
unit.
Important:
LThe setting should stay at 700 ms unless
pressing {FLASH} fails to pick up the
Call Waiting call.
1 {MENU} (center of joystick) i h i
{SELECT}
2 “Set tel line” i {SELECT}
3 “Set flash time” i {SELECT}
4 Select the desired line.
5 Select the desired setting. (Default:
“700ms”) i {SAVE} i {OFF}
1 {MENU} i h i {SET}
2 “Set tel line” i {SET}
3 “Set flash time” i {SET}
4 Select the desired line.
5 Select the desired setting. (Default:
“700ms”) i {SET} i {STOP}
Note for handset and base unit:
LIf the unit is connected via a PBX, certain
PBX functions (call transferring, etc.)
may not work correctly. Consult your
PBX supplier for the correct setting.
Handset
Base unit
Handset
Base unit
TH112(e).book Page 46 Tuesday, July 18, 2006 3:54 PM