Filter
Top Products
Location of Controls
8
Handset soft keys
Two soft keys are used to select functions displayed
directly above each key. Functions displayed above the
keys will change depending on the state of use.
On this sample display, “ (VE)” and “Mute ” are
displayed above soft keys.
• When a function name does not appear above a soft key, the soft key has no
function.
Handset navigator key
Scrolls up [
B
] and down [
d
] the function menu, the Caller
List and the phone book.
Increases [
B
] or decreases [
d
] the handset ringer and
receiver/speaker volumes.
Base unit display
1 “ ” flashes when no new messages can be
recorded. Erase unnecessary messages (p. 47).
2 “E” flashes until you set the date and time, and
flashes after a power failure. If it is flashing, set the
date and time (p. 14).
3 “ ” functions as follows.
• “ ” displays when a handset is operating the Answering System.
4 Message counter shows:
—the total number of recorded message s. If the recording time is set to
“Greeting only”, “ ” will be displayed (p. 20).
—the se lected volume level while you are adjusting the volume (p. 19).
—“ ” when your greeting message was not recorded correctly (p. 19).
Throughout these Operating Instructions:
• The sof t keys are indicated by what is displayed above the keys.
Ex. “Press Mute.” indicates “Press the soft key below Mute ”.
• The navigator key is indicated by the arrows [
d
] or [
B
].
Off (invisible) The line is free.
On The line is being used.
Flashing
A call is on hold on the handset or the Answering
System is answering a call (p. 42).
Flashing rapidly A call is being received.
J 5
Talk
00-00-32
K
(VE) Mute
L
KL
L
FULL
LINE IN USE
12
3
4
FULL
LINE IN USE
IN USE
Pressing the right soft key selects mute “Mute
”.
Pressing the left soft key selects Voice Enhancer “ (VE)
”.
L
K
PQQX13984YA.book 8 ページ ２００４年３月１５日 月曜日 午前８時２６分