Filter
Top Products
Programmable Settings
18
Ringer Tone
You can set the hand set ringer to use one of 7 ringer patterns for outside calls.
“Tone 1” to “Tone 3” are bell ringer patterns. “Melody 1” to “Melody 4” are melody
patterns. The factory preset is “Tone 1”.
• You cannot change the ringer tone for intercom calls.
• If you subscribe to a Distinctive Ring Service (such as IDENTA -RING) from your
telephone company with 2 or 3 consecutive rings, select a bell ringer p attern
(Tone 1 to 3). If you select a melody pattern, you will not be able to distinguish
lines by their ringers.
• If you select one of the melody ringer patterns, the ringer will continue to sound for
several seconds if:
— the caller hangs up before you answer the call, or
— a nother person answers the call using another phone connected on the same line.
LCD Contrast
There are 6 levels of LCD contrast. The factory preset is “level 3”.
1 Press [MENU].
2 Scroll to “Ringer setting” by pressing [
d
]
or [
B
], then press Select.
3 Scroll to “Ringer tone” by pressing [
d
] or
[
B
], then press Select.
4 Select the desired ringer tone by pressing [
d
]
or [
B
].
• The handset will ring and the ringer tone will
change. If the ringer volume has been turned off,
the handset will not ring (p. 17).
• You can also select the ringer tone by pressing [1]
to [7].
5 Press Save, then press [OFF].
1 Press [MENU].
2 Scroll to “ Initial setting” by pressing [
d
]
or [
B
], then press Select.
3 Scroll to “LCD contrast” by pressing [
d
] or
[
B
], then press Select.
4 Select the desired contrast by pressing [
d
] or
[
B
].
• The contrast will change.
5 Press Save, then press [OFF].
Handset
Ringer setting
Back Select
K
d
BL
Ringer tone
Back Select
K
d
BL
Ringer tone
1:Tone 1
Back Save
K
d
BL
Handset
LCD contrast
Back Select
K
d
BL
Ex. Level 3
LCD contrast
Low High
Back Save
K
d
BL
PQQX13984YA.book 18 ページ ２００４年３月１５日 月曜日 午前８時２６分