Filter
Top Products
Preparing the Answering System
20
To review the greeting
Press [GREETING CHEC K] .
To erase the greeting
Press [GREETING CHEC K] , then press [ERASE] while the recorded
message is being played.
• The unit will answer calls with a pre-recorded greeting (see below).
Pre-recorded greeting
If you do not record a greeting (p. 19), one of two greetings will be played when a
call is received, depending on the caller’s recording time (see below).
To review the pre-recorded greeting, press [GREETING CHECK].
• A pre-recorded greeting will be played as follows :
■ When the recording time is set to “1 minute”, “2 minutes” or “3 minutes”:
“Hello, we are not available now. Please leave your name and phone number after the
beep. We will return your call.”
• If recording time runs out, the unit will automatically switch to the “Greeting only”
mode (see below), and no new messages will be recorded.
■ When the recording time is se t to “Greeting only”:
“Hello, we are not available now. Please call again. Thank you for your call.”
Caller’s Recording Time
You can select “1 minute”, “2 minutes”, “3 minutes” or “Greeting only” for the caller’s
recording time. The factory preset is “3 minutes”.
Flash Memory Messa ge Backup (Message storage)
Messages stored in memory will not be affected by power failures. All messages
are saved until you erase them.
1 Press [MENU].
2 Scroll to “ Initial setting” by pressing [
d
]
or
[
B
], then press Select.
3 Press Select at “Set answering”.
4 Scroll to “Recording time” by pressing [
d
]
or
[
B
], then press Select.
Handset
Initial setting
Back Select
K
d
BL
Set answering
Back Select
K
d
BL
Recording time
Back Select
K
d
BL
PQQX13984YA.book 20 ページ ２００４年３月１５日 月曜日 午前８時２６分