Filter
Top Products
Programmable Settings
14
Date and Time
We recommend you set the date and time so that the unit will announce the day
and time each message was recorded when you play back messages.
• When entering the time in step 3, yo u cannot enter numbers greater than 12. Do
not use military time. (To set 13:00 hours, enter “0100”, then select “PM” in
step 4.)
To confirm the date and time, repeat steps 1 and 2 above.
• The current date and time are displayed. When finished, press [OFF].
1 Press [MENU].
2 Scroll to “Date and time” by pressing [
d
] or
[
B
], then press Select.
3 1 Enter 2 digits each for the month, day, and
year. (Ex. To set May 15, 2004, en te r “0 5
15 04”.)
2 Enter 4 digits for the time (hour and
minute). (Ex. To set 9:30, enter “0930”.)
• If you enter a wrong number, press [
d
] or [
B
] to
move the cursor to the incorrect number. Enter the
correct number.
4 Select “AM” or “PM” by pressin g AM/PM.
5 Press Save.
• The d ate and time are set and “E” disappears
from the base unit display.
• If the handset beeps 3 times, the date and time
were not set correctly. Start again from step 3.
6 Press [OFF].
The date and time may be incorrect after a power failure. When “E” flashes on
the base unit display, set the date and time again.
For Caller ID service users (p. 27)
• When a call is received, Caller ID informa tion adjust the date and time if the
time is incorrect.
• Caller ID information will automatically adjust the date and time for daylight
saving time.
• If the date and time has not previously been set, Caller ID information will not
adjust the date and time.
Handset
Date and time
Back Select
K
d
BL
Example
Date:
|
12.31.2004
Time:12:00 AM
AM/PM Save
K
L
Date:
|
05.15.2004
Time:09:30 AM
AM/PM Save
K
L
Date:
|
05.15.2004
Time:09:30 AM
AM/PM Save
K
L
PQQX13984YA.book 14 ページ ２００４年３月１５日 月曜日 午前８時２６分