Filter
Top Products
Station Features and Operation (DPT/SLT)
144 User Manual
<PT>
• The destination extension shows the Caller ID and the extension number from where the
call was transferred on the display.
<Example> The Caller ID number "123456789" is transferred from extension 101.
The priority of the display is:
Caller ID name > Caller ID number > Outside line name > Blank (if none of these is
assigned).
If your telephone has a two, three or six line display, both the Caller ID name and
number are displayed.
You can change the display to show the original extension number and name by System
Programming.
• A flexible CO button can be assigned as a DSS button.
• To use "One-Touch Transfer", System Programming is required.
• Pressing the FLASH or FLASH/RCL button while dialing clears the display. Then you
can enter the revised number.
• If you want to return to the held call, press the TRANSFER button or corresponding CO,
INTERCOM button before the destination extension answers.
• When "Transfer Recall" occurs, the display shows:
<Example>
<SLT>
• If you want to return to the held call, flash the hookswitch before the destination
extension answers.
<ISDN Telephone>
• This feature is not available for ISDN telephones.
Programming Guide References
[108] Automatic Hold by CO / DSS Button
[201] Transfer Recall Time
[990] System Additional Information
User Manual References
2.2.2 Flexible Button Assignment
4.3.87 Uniform Call Distribution (UCD)
101 123456789
RCL: Ext 103