Filter
Top Products
77
Useful Information
Problem
The unit does not display the
caller’s phone number.
The handset display goes to
the standby mode while
viewing the Caller List.
(LOCATOR/INTERCOM) does
not function.
You cannot redial by
pressing (REDIAL/PAUSE).
Remedy
•You need to subscribe to a Caller ID
service from a telephone company.
•Other telephone equipment may be
interfering with your phone. Disconnect
it and try again.
•Other electrical appliances connected to
the same outlet may be interfering with
the Caller ID information.
•Telephone line noise may be affecting
the Caller ID information.
•Do not pause for over 60 seconds while
searching.
•The handset is too far from the base unit.
•The handset is engaged in an outside
call, viewing the Caller List/directory list
or listening to messages. Wait until the
IN USE/CHARGE indicator light goes
out.
•If the last number dialled was more than
32 digits long, the number will not be
redialled correctly.
•The button has a double function as
either redial or pause. It will redial the
last number dialled if pressed at the
outset of a call (p. 28, 29, 31). If another
number has been dialled first, it will
operate as a pause button (p. 54).