Filter
Top Products
25
Preparation
Programming Summary for the Answering System
You can program the following functions using the handset near the
base unit. See the page numbers below for details.
Make sure the unit is in the standby mode initially.
•You can exit the programming mode any time by pressing (EXIT/CH).
•If you do not press any buttons for 60 seconds, the unit will return to the standby
mode.
•If 6 beeps sound on the base unit during programming, a wrong key was
pressed. Enter the correct number.
•If the handset has lost communication with the base unit, 3 beeps sound and “No
link to base Place on cradle and try again.” is displayed on the
handset.
Lift the handset, and press (FUNCTION/EDIT).
Press á (Save key).
Press Ö or Ñ to select “TAD program”, and press á (Yes key).
•“Answering system setting” is displayed on the handset.
G
G
G
Press Ö or Ñ to select “Program”, and press á (Yes key).
G
To set the remote code, press (1). (page 65)
To select the number of rings, press (2). (page 27)
To select the caller’s recording time, press (5). (page 26)
To store a pager number, press (#). (pages 62, 63)
•
The base unit display shows numbers or characters related to the adjustment
or settings.