Filter
Top Products
22
Storing Your Area Code
We recommend you program your area code before using the Caller ID
feature (p. 34). Incoming calls from the same area will be then recorded in
the Caller List without the area code. You do not have to remove the code
before calling back or storing.
Make sure the unit is in the standby mode initially.
To store your area code
1
Press (FUNCTION/EDIT).
2
Press Ö or Ñ repeatedly until the arrow
points to “Program”, and press á
(Yes key).
3
Press Ö or Ñ repeatedly until the arrow
points to “Set area code”.
4
Press á (Yes key).
5
Enter your area code.
•You can enter the number up to 8 digits
•If your enter a wrong number, press Ü.
The digits are 1erased from the right.
Area code
02
H
Save directory
Ringer volume
GF H
=Yes
Area code
02
H
=Save
Talk switching
H
Set area code
GF H
=Yes
Area code
Enter area code
For New Zealand Users:
Your telephone service provider may charge you for a local call when it
is dialled with an area code prefix. If the charge for local call is
unacceptable, store your area code as shown above before use, or
only the 7-digits of the local number should be dialled from your
telephone. Do not dial the “0” prefix or the area code digit.
H
Program
GF H
=Yes
6
Press á (Save key).
•A beep sounds.
•To return to the standby mode, press
(EXIT/CH).
•You can exit the programming mode any time by pressing (EXIT/CH).
To erase your area code, press (*) in step 5.
Programmable Functions