Filter
Top Products
19
EDITING A STORED NAME AND/OR
PHONE NUMBER
1) Press MEM, “Select Memory”
is displayed.
2) Press /VOL and /VOL, or enter a number (0 - 9) to select the
memory location you would like to edit.
3) Press SELECT twice. The following screen
appears with the memory location number
that you have selected on the display.
4) Press /VOL or /VOL to select “
Edit
MemoryXX” then press SELECT. The
following screen appears.
The cursor flashes indicating that the display
is ready for the name to be edited. When a name has not been stored,
the cursor appears at the beginning of the second line.
5) Use the number keys, /TONE/ , #/ , or CH/DELETE to edit the
name. (See page 15.)
To edit only the phone number, skip this step.
6) Press SELECT.
The following screen appears.
The cursor flashes indicating that the display
is ready for the number to be edited.
7) Use the number key, /TONE/ , #/ , PAUSE/REDIAL or
CH/DELETE to edit the phone number. The phone number cannot
exceed 20 digits. (See page 15.) If you don’t want to change the phone
number, skip this step.
8) Press MEM. A confirmation screen appears.
If it is correct, press /VOL to select “
Yes”
and press SELECT. The handset beeps
and displays the confirmation screen.
The memory storage is complete.
For example, if you store a name and
number into memory location number 1,
the display shows “
Memory01 Stored”.
After about 2 seconds, Select Memory
screen is displayed.
9) Press END to return to standby mode.
Select Memory
01 Bobby
02 SONIGEM
Edit Memory02
Delete Memory02
Go Back
Memory02 Stored
01 Bobby
02 SONIGEM
03 MOM AND DAD
Replace Memory
Yes
No
UP044DH (ST88245) OM resize 3/4/04 4:47 PM Page 19