Filter
Top Products
7
INSTALLATION
▼ On A Desk Top
1) Plug one end of the supplied
modular cord into the TEL LINE
jack on the back of the base.
2) Insert the supplied AC adapter’s
barrel plug into the DC IN 9V
jack on the back of the base and
route the adapter’s cord through
the strain relief slot on the base.
3) Plug the other end of the
modular cord into a modular
phone line jack.
4) Plug the adapter into a standard AC outlet.
CAUTION: You must use a Class 2 power source that supplies 9V
DC and delivers at least 210 mA. Its center tip must be
set to positive and its plug must fit the phone’s DC IN 9V
jack. The supplied adapter meets these specifications.
Using an adapter that does not meet these specifications
could damage the phone or the adapter.
▼ On A Wall Plate or Wall
To mount the phone directly on a wall, you need two screws (not supplied)
with heads that fit into the keyhole slots on the base.
Drill two holes 3 15/16 inches apart. Thread a screw into each hole, letting
the heads extend about 1/8 inch.
1) Insert the two of upper tabs of the
optional bracket (not included) into
the base’s upper tab slots.
Then slide down the bracket so
that two of the lower tabs would
be inserted into the lower slots.
TEL LINE
DC IN 9V
Bracket
(not included)
UP044DH (ST88245) OM resize 9/15/04 2:20 PM Page 7