Filter
Top Products
17
If you make a mistake while entering a name:
Use /TONE/ or #/ to move the cursor to the incorrect character.
Press CH/DELETE to erase the wrong character, then enter the correct
character. To delete all characters, press and hold CH/DELETE.
For example, to enter Bobby:
1) Pick up the handset. Press MEM.
2)
Enter a number or press
/VOL, /VOL
to select a memory location
number.
3) Press SELECT twice.
4) Press 2 twice.
5) Press 6 six times.
6) Press 2 five times, then press #/ to move the cursor to the right.
NOTE: If the next character uses the same number key, you must press #/ to
move the cursor over. Otherwise the next time you press the number
key, it changes the character that was previously set.
7) Press 2 five times.
8) Press 9 seven times.
9) When finished, press SELECT.
To continue to store the telephone number, proceed to step 6 on page 15.
MAKING CALLS WITH MEMORY DIALING
MEMORY DIALING FROM STANDBY MODE
1) Press MEM. The handset displays your programmed memory locations.
2) Press /VOL and /VOL, or enter the
number (0 - 9) to select the memory
location you would like to dial.
3) Press TALK/FLASH. “
Talk” and the
volume setting appear on the display.
Then the displayed number is dialed.
Select Memory
01 Bobby
02 SONIGEM
UP044DH (ST88245) OM resize 3/4/04 3:04 PM Page 17