Filter
Top Products
Subattendant User Guide for the Mitel 5340 IP Phone
Hotel/Motel Features
As the Subattendant in a hotel/motel, you can:
• Check current room status
• Change room occupancy and condition status
• Program multiple automatic wakeup calls that occur once or repeat daily
• Obtain a list and count of rooms by status and condition (Vacant/Clean, Vacant/Dirty, Maid in
Room, etc.)
• Request reports of all current wakeup calls, message register counts, and status of rooms
• Block room to room calling
• Assign outgoing call privileges on a room to room basis
• Request a printout of wake-up calls, message register count, DID number and room status
Hotel/motel features are accessed through the Guest Room feature key on the 5340 IP Phone. The
individual features are then available on softkeys.
Hotel/motel features can be accessed whether the 5340 IP Phone is idle or in the process of handling a
call. While you are handling a call from a guest room, press the Guest Room key and the phone display
shows information about the source of the call). The message area (second and third line of the display)
indicates Room Number, Name, the state (busy or idle) of the room extension, whether Do Not Disturb
(DND) is set and messages are waiting (MWI) and the message register (R) count. The feature softkeys
are on the succeeding lines.
11:03a 10-JUL-03
11110 EXEC. SUITE
IDLE DND MWI R=12345
DND
Wake-Up Status*
Print DID O/G Rest*
More…
*label determined by system
programming
Figure 1. 5340 Display when Guest Room key pressed while handling call
Table 1. Guest Room Feature Keys
Key Description
Wake-Up
Press this key to change or update existing wake-up times. See Setting and Canceling
Wake-up Times on page
11. If this room is part of a guest suite, refer to Suite Services
on page
12.
Print DID
Press this key to request a DID number printout (for rooms with DID number assigned).
DND
Press this key to toggle the Do Not Disturb feature.
Status or
O/G Rest
The appearance of this key is dependent on system programming. Press the Status
key to change or update the status/condition of a room. See Displaying and Changing
Room Data on page
10.
If "Outgoing Call Restriction" is enabled in your system programming, press the O/G
Rest key to set call restriction to Local, Long Distance, or Internal.
-8-