Mitel 5235 IP Phone Telephone User Manual


 
5235 IP Phone SIP User and Administrator Guide
View a User Name
1. Press Superkey.
2. Press the Line 3 key. The user display name (top) and user name (bottom)
appears.
3. Press Superkey to return to the default display.
Device Parameters
To view the software version and the MAC address:
1. Press Superkey, and then press >> until ADMIN TOOLS? appears on the display.
2. Press OK. DEVICE PARAMETERS? appears.
3. Press OK. SOFTWARE VERSION appears.
4. View either the software version or the MAC address.
To view the software version, press REVIEW (the current software version
appears), then press OK. SOFTWARE VERSION reappears.
To view the MAC address, press NEXT (MAC ADDRESS appears), then press
REVIEW. The current MAC address appears. Press OK. MAC ADDRESS
reappears.
5. Do one of the following:
To return to the main menu, press EXIT.
To return to the default display, press Superkey.
Note: You can also view the MAC address using the Line 1 key (see
View the IP and
MAC Addresses
on page 31).
Protocols
For information about supported communication and media protocols, access the Web
Configuration Tool online Help (see
Accessing the Web Configuration Tool Online Help
on page
3).
Enable/Disable Protocols
To enable/disable protocols using the Web Configuration Tool:
Access the tool’s Protocols page.
Note: To access the Web Configuration Tool, HTTP must be enabled. If HTTP is
disabled and you need to access the tool, enable HTTP through the Superkey
Menu Interface (see procedure that follows below).
To enable/disable protocols using the Superkey Menu Interface:
1. Press Superkey, and then press >> until ADMIN TOOLS? appears on the display.
2. Press OK, and then press Next until ACCESS PROTOCOLS? appears on the
display.
- 30 -