Mitel 5235 IP Phone Telephone User Manual


 
Call Handling
Call Handling
Hold
The 5235 IP Phone supports a maximum of eight held calls at the same time.
When you place a call on hold, or when another party puts you on hold, the on-hold
beep reminds you that you are holding or on hold. If the handset is in its cradle, you hear
the beep through the handsfree speaker. You can turn off this beep, if desired.
Note: You cannot change your hold settings while on a call.
Hold a Call
Press HOLD. The associated Line key flashes.
Retrieve a Call from Hold
Press the associated flashing Line key. The Line key changes from flashing to lit
solid.
Change On-Hold Settings
Access the Feature Configuration page of the Web Configuration (see Accessing
the Web Configuration Tool
on page 6).
Call Forward
Call Forward redirects incoming calls to your voice mailbox (by default) or to an alternate
number. Choose from the following Call Forward options:
Call Forward – Always redirects all incoming calls
Call Forward – No Answer redirects calls if you don’t answer after the programmed
number of rings (1 – 99)
Call Forward – Busy redirects calls when all lines are busy.
All Call Forward options are OFF by default. You can turn on Call Forward No Answer
and Call Forward Busy at the same time.
Note: You cannot change your Call Forward settings while on a call.
Note: To program and enable or disable Call Forward using the Web Configuration
Tool, access the tool’s Feature Configuration page (see
Accessing the Web
Configuration Tool
on page 6).
- 17 -