Filter
Top Products
SP200/210 Maxon SP200/210 Radio
Issue 1.0 INSTALLATION, COMMISSIONING & ALIGNMENT
03/01 Page 4-5
SK 3100 Service Kit
3
2
1
4
Figure 4-8 - SK 3100 Service Kit
This kit can be used for commissioning in the same way as the SK2055 (ignoring computer
connections). The above kit also includes a battery eliminator.
Note
: If the Interface Box is used, ensure that it is set to manual, Audio enable is off and PTT is off
before powering up.
If programming the radio with the Battery eliminator connected, the curly cord must be disconnected
from the Interface Box.
The SK 3100 service kit is used with the
SP200/210 radio and provides most of the
interface cables and tools which will be required
for test and alignment of the SP200/210.
The SK 3100 Service Kit
does not
provide the
programming cable, ACC-2002. This is
available as part of the SMP6100
Programming Kit (see Section 3).
1. ACC-2003 Radio Interface Test Box. This
provides an audio interface, a battery
eliminator / programming interface and a
PTT switch.
2. ME210089 SMA to BNC Adapter
3. Trimmer Tools. These are used to adjust
the trimmers and ferrite cores within the
radio.
4. ME110016 Flexi-PCB. Used to
interconnect the Digital and RF pcbs for
servicing.
Prerequisites
For the following tests, signal generator
modulation level should be set to Average
System Deviation, i.e. 60% of maximum
system deviation.
The level should therefore be set to:
1.5 kHz for 12.5 kHz channel spacing
2.4 kHz for 20 kHz channel spacing
3.0 kHz for 25 kHz channel spacing
If the radio has had components installed to
change the channel spacing and/or operating
band from those installed at the factory,
ensure that the correct components are
installed in the receiver and transmitter stages
prior to testing.
Refer to the appropriate Electrical Parts List if
necessary.