Filter
Top Products
Iris Touch 200 Range Dialer Installation Manual10
7.2. Default alarm messages
The default SIA messages for each PIN are shown below:
Pin ‘Set’ message ‘Restore’ message Meaning
1 NBA01 NBR01 Burglary alarm/restore
2 NFA02 NFR02 Fire alarm/restore
3 NQA03 NQR03 Emergency alarm/restore
4 NOP04 NCL04 Open/close
8. Relay outputs
The IRIS dialer has two relay outputs [20] that can be used in a number of
ways:
• To indicate communications path failure.
• Activation by incoming SMS Message.
• Setting by the Monitoring Centre.
The relay contacts are normally open and closed when activated.
Wire to these contacts as required and define how they are to be used using the
configuration options on the Settings Menu. See Appendix A for more details.
9. Troubleshooting
Problem Resolution
No screen display when IRIS
dialer is connected to the
power.
Check that there is power to the system
and that the wiring is the correct polarity.
A fault develops and is
indicated by the LED on the top
of the unit flashing.
Touch the display and the instructions will
guide you through identification of the
problem.
Go to the Installers menu and select Test to
use the integrated test function.