Ericsson 230 Cordless Telephone User Manual


 
Not
f
or Comm
e
r
c
ia
l
Use
E
ricsson Mobile
Com
m
unic
a
t
i
ons A
B
Extra features 71
Connecting to a base station
To be able to use a certain base station, the handset must be subscribed and
connected to that base station. A handset can be subscribed to multiple base
stations, but can only be connected to one base station at a time. To connect to
a base station please refer to “Selecting another base station” on page 80.
Your base station can operate in the single-cell (stand alone) mode or in the
multi-cell mode. In the multi-cell mode, the handset can be used in a larger
area in which base stations work together as one unit. It is recommended that
you leave your base station in the single-cell mode unless otherwise specified.
This function is reserved for future use.
To set the cell mode:
Route:
BaseStation » Basic » CellMode
1. Select
Basic
and press YES.
PIN:
is displayed.
2. Enter the PIN code for the base station (see page 58) and press
YES.
3. Select
CellMode
and press YES.
The current cell mode is displayed.
4. Press
UP or DOWN to select one of the following options:
SingleCell
default setting; the base station operates in stand alone mode.
MultiCell
the base station works together with other base stations to form
a larger coverage area.
5. Press
YES to confirm.
The cell mode is set.
If the base station is connected to a switchboard, you can use its functions in
the same way as with a conventional fixed telephone. The only difference is
the absence of a telephone cable. One example of this type of function is
transferring calls.
Telephoning using a switchboard
When you use a switchboard, it is sometimes necessary to wait for the dial
tone before dialling a number. If the whole number is to be entered and dis-
played prior to dialling, for example a stored number, then you must indicate
where in the number the handset should wait for the dial tone.
To include a pause (to wait for the dial tone) in a number, press
for one sec-
ond. A dash appears in the handset display to show you where you have set the
pause.
SINGLE OR MULTI-CELL MODE
USING A SWITCHBOARD