Filter
Top Products
10
2.6 POWER MODULE INSTALLATION
The section describes the procedure for installation of the power module (part number 00753-9220-0001). The
power module should stored in a safe place with a controlled environment until the Model 6081 is ready for live
operation. For first time installation of the power module, follow these steps:
1. Unscrew the two long machine screws to remove the rear cover of the Model 6081. Separate the
rear cover from the central housing by manually prying the sections apart. Do not use screwdrivers or
tools to separate these housing parts. The parts are sealed with an o-ring.
2. Before installation, note the safety warning, disposal instructions and part information on the connection-
side label of the power module.
3. With the Model 6081 front display section facing away from you, align the power module pack with the
curved surface of the pack facing towards you and the small protruding connector facing away from you.
Make sure to align the power module and its keyed connector with the connection receptacle in the middle
of the instrument’s terminal block area.
MODEL 6081-P pH/ORP SECTION 2.0
INSTALLATION
Figure 2-4. Power Module Warning Label
Figure 2-5. Installing the Power Module
Figure 2-3. Removing rear cover