Filter
Top Products
Removing and Installing Parts 125
NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug it
into the computer.
7
Connect your computer and devices to electrical outlets, and turn them on.
8
Enter system setup (see "System Setup" on page 131) and restore the settings you recorded in
step 1.
9
Properly dispose of the old battery. See the
Product Information Guide
for battery disposal
information.
Closing the Computer Cover
1
Ensure that all cables are connected, and fold cables out of the way.
2
Ensure that no tools or extra parts are left inside the computer.
3
Pivot the cover down and into position.
4
Press down on the cover to close it.
5
Once the cover is closed, slide the release latch to the right until the latch clicks into place.
6
If you are using a padlock to secure your computer, install the padlock.
NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug it
into the computer.
7
Connect your computer and devices to electrical outlets, and turn them on.
padlock ring
cover release
latch
security
cable slot