Dell XPS 600 Telephone User Manual


 
100 Removing and Installing Parts
www.dell.com | support.dell.com
9
Connect a power cable to the drive.
10
Connect the hard-drive cable to the drive and to the system board (see "System Board
Components" on page 78).
11
Check all connectors to be certain that they are properly cabled and firmly seated.
NOTICE: When replacing the hard-drive shroud, ensure that all the cables are properly routed.
12
Insert the bottom tabs of the shroud into the slot on the drive cage and rotate the shroud up.
13
Press the top shroud tabs towards each other and insert them into the corresponding slot on
the chassis.
14
Gently press on the shroud to ensure that it is secure.
15
Close the computer cover (see "Closing the Computer Cover" on page 125).
NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug it
into the computer.
16
Connect your computer and devices to electrical outlets, and turn them on.
See the documentation that came with the drive for instructions on installing any software
required for drive operation.