Filter
Top Products
Powering the Pegaso
6 Pegaso™ Industrial PDA with Windows
®
CE
Installing the Battery Pack
The Pegaso’s Battery and its cover are integrated — they do not come apart.
Complete the following instructions to install the battery pack:
1. Loosen the elastic handstrap by releasing it from the bottom of the unit
(refer to the PRG).
2. Orient the battery pack with the latch facing toward the top of the Pegaso
(refer to
Figure 2 on page 7).
3. Replace the battery door by inserting the bottom tab into the unit, then
clicking the latch into place. If the battery pack is installed incorrectly, it
will not seat properly.
4. Replace the handstrap at the bottom of the unit.
WARNING
Lithium-ion battery packs may get hot, explode, ignite, or/and cause
serious injury if exposed to abusive conditions.
• Do not place the battery in or near fire, direct sunlight, or other
high temperature locations, or heat the battery.
• Do not connect the positive terminal and negative terminal of the
battery to each other with any metal object (such as wire or coin).
• Do not expose the battery to liquids, or allow to get wet.
• Do not disassemble, modify, or pierce the battery. The battery con-
tains safety and protection devices, which, if damaged, may cause
the battery to generate heat, explode or ignite.
In the event the battery leaks and the fluid gets into your eye, do not
rub the eye. Rinse well with water and immediately seek medical care.
If left untreated, the battery fluid could cause damage to the eye.
Datalogic recommends annual replacement of rechargeable battery
packs to ensure maximum performance.
When you first remove the Pegaso from the box, you must charge
both the battery pack and the backup battery for a minimum of 4
hours.