Filter
Top Products
4-5
Cisco VG202, Cisco VG202XM, Cisco VG204, and Cisco VG204XM Voice Gateways Software Configuration Guide
OL-16191-01
Chapter 4 Configuring Voice
Auto-Configuration on the Cisco VG202, Cisco VG202XM, Cisco VG204, and Cisco VG204XM Voice Gateways
Auto-Configuration Without a DHCP Server
When the DHCP server is not available, use the following commands to provision the voice gateway with
the CUCM configuration.
SUMMARY STEPS
1. enable
2. configure terminal
3. interface type slot/port
4. ip address static ip subnet mask
5. sccp local interface-type interface-number port port-number
6. voice service voip
7. fax protocol t38 [nse[force]]
8. ccm-manager sccp local interface-type interface-number
9. ccm-manager config server tftp_ip_address
10. ccm-manager sccp
Step 6
ccm-manager sccp local interface-type
interface-number
Example:
VG(config)# ccm-manager sccp local fastethernet
0/0
Selects the local interface that the SCCP application uses
to register with CUCM.
Step 7
ccm-manager sccp
Example:
VG(config)# ccm-manager sccp
Enables CUCM autoconfiguration of the Cisco IOS
gateway.
Note The ccm sccp command will remove itself if
there is no IP address configured. The command
checks every 20 seconds, up to a maximum of 8
times, then the Cisco IOS gateway will be
automatically unconfigured.
Step 8
voice service voip
Example:
VG(config)# voice service voip
Enters voice-service configuration mode and specifies a
voice-encapsulation type.
Note This step is not necessary through
auto-configuration.
Step 9
fax protocol t38 [nse[force]]
Example:
VG(config)# fax protocol t38 nse force
Specifies the global default ITU-T T.38 standard fax
protocol to be used for all VoIP dial peers.
Note This step is not necessary through
auto-configuration.
Step 10
exit
Example:
VG(config-line)# exit
Exits to global configuration mode.
Command or Action Purpose