Filter
Top Products
2-2
Cisco VG202, Cisco VG202XM, Cisco VG204, and Cisco VG204XM Voice Gateways Software Configuration Guide
OL-16191-01
Chapter 2 Configuring Your Voice Gateway Using the setup Command
Using the setup Command
Step 4 Determine the addressing plan for each network protocol.
Using the setup Command
The setup command is displayed in your PC terminal emulation program window.
Note If you make a mistake while using the setup command, you can exit and run the command again. Press
Ctrl-C, and enter setup at the enable mode prompt (VG#).
Procedure
Step 1 Plug in the external power supply.
The system begins to display messages in your terminal emulation program window.
Caution The voice gateway does not enter setup mode during the initial configuration. During initial
configuration, the voice gateway boots up in auto-configuration. You can only use the setup command
to configure the voice gateway manually after the initial configuration. Using the setup command during
the initial configuration erases the default configuration and must be avoided.
Caution Do not press any keys on the keyboard until the messages stop. The system interprets any keys pressed
during this time as the first command typed when the messages stop, which might cause the voice
gateway to power off and start over. It takes a few minutes for the messages to stop.
The messages look similar to the following example.
System configuration has been modified. Save? [yes/no]: n
Proceed with reload? [confirm]
*Apr 21 14:23:38.051: %SYS-5-RELOAD: Reload requested by console. Reload Reason: Reload
Command.
System Bootstrap, Version 12.4(20080415:092610)
[anyname-VG.V124_19_9_2_PIA9.14582.ios.sync 102], DEVELOPMENT SOFTWARE
Copyright (c) 1994-2008 by cisco Systems, Inc.
VG202 platform with 131072 Kbytes of main memory
Upgrade ROMMON initialized
program load complete, entry point: 0x80020000, size: 0x1437d40
Self decompressing the image:
##########################################################################################
##########################################################################################
################################# [OK]
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph