Filter
Top Products
3-3
Cisco VG202, Cisco VG202XM, Cisco VG204, and Cisco VG204XM Voice Gateways Software Configuration Guide
OL-16191-01
Chapter 3 Configuring Your Voice Gateway Using the CLI
Configuring Fast Ethernet Interfaces
Using 1888 out of 126968 bytes
!
version XX.X
.
.
.
!
hostname VG204
!
enable secret 5 $1$60L4$X2JYOwoDc0.kqa1loO/w8/
.
.
.
Step 2 Check the hostname and encrypted password displayed near the top of the command output.
Step 3 Exit global configuration mode and attempt to reenter it, using the new enable password:
VG# exit
.
.
.
VG con0 is now available
Press RETURN to get started.
VG> enable
Password: guessme
VG#
Tip If you are having trouble, ensure the following:
• Caps lock is off.
• You entered the correct passwords. Passwords are case sensitive.
Configuring Fast Ethernet Interfaces
To configure a Fast Ethernet interface, use the configuration software provided with your voice gateway.
Otherwise, for greatest power and flexibility, use configuration mode (manual configuration).
This section describes basic Fast Ethernet interface configuration, including enabling the interface and
specifying IP routing. Depending on your own requirements and the protocols you plan to route, you
might also need to enter other configuration commands.
Before You Begin
• Connect a console to the voice gateway.
• Power on the voice gateway by plugging in the external power supply.
SUMMARY STEPS
1. enable
2. configure terminal
3. ip routing