Filter
Top Products
2-9
Cisco Unified Communications Manager Configuration Guide for the Cisco TelePresence System
OL-21851-01
Chapter 2 Configuring the CiscoUnified IP Phone for MIDlets
Configuring the Cisco Unified IP Phone
• Leave fields in the External Data Locations Information table blank to use the default settings.
Tip Be careful when typing URLs to avoid typos.
External Data Location Settings for CTS Release 1.6 and Earlier
Table 2-5 External Data Location Settings for CTS Release 1.6 and Earlier
Field
Required
Non-MIDlets
Required for
MIDlets Setting
Information — Yes Leave blank to use the default.
Note Default settings that were configured in the Enterprise
Parameters Configuration.
Directory
Messages
Services Yes No Leave blank to use the default.
Authentication
Server
Yes No http://server:8080/authenticate.html
Note For CTS release 1.6 systems with MIDlets and earlier
(only allowable option)
Proxy Server — — Leave blank to use the default.
Idle Yes No Leave blank to use the default.
Idle Timer (seconds) Yes—1 — For MIDlets, you do not have to supply a value in the Idle Timer
field. Or you can enter 0 (zero).
Secure
Authentication URL
—Yes (CUCM
Release 8.0 only)
Must match the URL in the Authentication Server field above. For
example: http://server:8080/authenticate.html
Secure Directory
URL
—Yes (CUCM
Release 8.0 only)
Enter the secure URL for the server from which the phone obtains
directory information. This parameter specifies the URL that
secured Cisco Unified IP Phones use when you press the Directory
button.
Note If you do not provide a Secure Directory URL, the device
uses the nonsecure URL. If you provide both a secure URL
and a nonsecure URL, the device chooses the appropriate
URL, based on its capabilities.
Leave this field blank to accept the default setting.
Maximum length: 255
Secure Idle URL — Yes (CUCM
Release 8.0 only)
Leave blank to use the default.
Secure Information
URL
—Yes (CUCM
Release 8.0 only)
Leave blank to use the default.
Secure Message
URL
—Yes (CUCM
Release 8.0 only)
Leave blank to use the default.
Secure Services URL — Yes (CUCM
Release 8.0 only)
Leave blank to use the default.