Filter
Top Products
2-8
Cisco Unified Communications Manager Configuration Guide for the Cisco TelePresence System
OL-21851-01
Chapter 2 Configuring the Cisco Unified IP Phone for MIDlets
Configuring the Cisco Unified IP Phone
Expansion Module Information
Table 2-4 describes fields found in the Expansion Module Information section on the Phone
Configuration page. Leave all fields unchanged.
External Data Locations Information
Define the server locations for external data using the information in the following sections as a guide:
• External Data Location Settings for CTS Release 1.6 and Earlier—Table 2-5
• External Data Location Settings for CTS Release 1.7 and Later—Table 2-6
Note Observe the Following—The server designation can be either the IP address or the hostname of the
Cisco TelePresence device that is associated with this phone.
If a server hostname is used, it must be resolvable by the Cisco Unified IP Phone 7970 Series DNS.
• The format for each required field is http://server hostname: or IP address: Followed by the 8080
port address, then a slash and one of the following, depending on the field:
–
services.html
–
getservicesmenu.jsp
–
authenticate.html - For CTS release 1.6 systems with MIDlets and earlier (only allowable
option)
–
idle.html
Table 2-3 CAPF Settings
Field Required? Setting
Certificate Operation Yes No Pending Operation.
Authentication Mode Yes Leave this field unchanged.
Authentication String —
Key Size (Bits) Yes
Operation Completes By Optional
Certificate Operation Status — <None>
Note Security Profile Contains Additional CAPF Settings. See the “Phone Security Profile CAPF
Information” section on page 1-30.
Table 2-4 Expansion Module Information
Field Required? Setting
Module 1 — <None>
Module 1 Load Name — Leave blank.
Module 2 — <None>
Module 2 Load Name — Leave blank.