Filter
Top Products
2-10
Cisco Unified Communications Manager Configuration Guide for the Cisco TelePresence System
OL-21851-01
Chapter 2 Configuring the Cisco Unified IP Phone for MIDlets
Configuring the Cisco Unified IP Phone
External Data Location Settings for CTS Release 1.7 and Later
Note CTS Release 1.7 and later releases require that your system be running MIDlets.
Extension Information
Table 2-7 describes fields found in the Extension Information section on the Phone Configuration page.
Note Leave all fields unchanged.
Table 2-6 External Data Location Settings for CTS Release 1.7 and Later
Field Setting
Information Leave all fields blank to use the default.
Note Default settings that were configured in the Enterprise Parameters
Configuration.
Directory
Messages
Services
Authentication
Server
Proxy Server
Idle
Idle Timer
(seconds)
Set to 0 to use the default.
Secure
Authentication
URL
Leave all fields blank to use the default.
Secure Directory
URL
Enter the secure URL for the server from which the phone obtains directory
information. This parameter specifies the URL that secured Cisco Unified IP
Phones use when you press the Directory button.
Note If you do not provide a Secure Directory URL, the device uses the
nonsecure URL. If you provide both a secure URL and a nonsecure URL,
the device chooses the appropriate URL, based on its capabilities.
Leave this field blank to accept the default setting.
Maximum length: 255
Secure Idle URL —
Secure
Information URL
—
Secure Message
URL
—
Secure Services
URL
—