Filter
Top Products
Cisco Unified IP Phone 7975G Phone Guide for Cisco Unified Communications Manager 6.1(3) (SCCP and SIP) 29
Tips
• Enter the call forward target number exactly as you would dial it from your phone. For example,
enter an access code or the area code, if necessary.
• You can forward your calls to a traditional analog phone or to another IP phone, although your
system administrator might restrict the call forwarding feature to numbers within your company.
• Call forwarding is phone line specific. If a call reaches you on a line where call forwarding is not
enabled, the call will ring as usual.
• Your system administrator can enable a call forward override feature that allows the person
receiving your forwarded calls to reach you. With override enabled, a call placed from the target
phone to your phone is not forwarded, but rings through.
• Your system administrator can change call forwarding conditions for your phone lines.
Using Do Not Disturb
You can use the Do Not Disturb (DND) feature to block incoming calls from ringing your phone. Your
system administrator enables DND for your phone.
When DND and Call Forward are both enabled on your phone, calls are forwarded and the caller does
not hear a busy tone.
Your intercom lines still ring when DND is active.
If you want to... Then...
Set up Call Forward All on your primary line Press CFwdALL or Forward All and enter a target
phone number.
Cancel Call Forward All on your primary line Press CFwdALL or Forward All.
Verify that Call Forward All is enabled on your
primary line
Look for:
• The call forward icon above the primary
phone number.
• The call forward target number in the status
line.
If you want to... Then...
Turn on DND Press DND or Do Not Disturb .
“Do Not Disturb” displays on the phone, the DND lights,
and the ring tone is turned off.