Filter
Top Products
56
2. In the upper part of the Trainer dialog box, select the segments or
parts of the ink pattern that you want to use as a character.
Note
• Tap the ink pattern to select it, tap it again to deselect. If there is
more than one stroke, make sure you select all the strokes that are
part of the character. The strokes you select appear in the Trainer
dialog box, which shows the ink pattern that will be used for
recognition.
3. Tap the down arrow next to the As box and select the character
from the list that appears.
• If you cannot find the character you want in the list, select Other.
See “Other Symbols” below.
• You can also use the stylus to write the text character you want
directly into the As box.
• No matter how you specify a character, the character in the As box
will be associated with the ink pattern in the Trainer dialog box.
4. Tap the Train button to train the character and save your changes
to the Library of Models.
5. Tap the close box
to close the Trainer dialog box.
Other Symbols
If the character you want is not in the list, select Other from the list to
open the Train Symbol dialog box.
The Train Symbol dialog box provides a selection of non-standard
and international symbols. Tap the character you want on the Train
Symbol dialog box to select it, and then tap OK.
The following functions are also available on the Trainer dialog box.
• Tap the Undo button if you made a mistake and want to “untrain”
the character.
• Tap the Macro button when you want to train the selected ink
pattern as a character string, macro, or gesture. Tapping Macro
displays the Train Macro Wizard, which shows the selected ink
pattern. See “Macros & Gestures” on page 57 for more information
about this dialog box.