Filter
Top Products
5900335 © 2005 JCM-American Corporation
12-3
PALM PILOT® USAGE Optipay™ CC Section 12
c). Float-up function warning (See Figure 12-
8).
7. Setting Coin Changer “Security Stock”
quantities.
a). Configure the “Security Stock” for each
tube by using the drop
down menu’s triangular “up” and
“down”arrows to set the desired value
(See Figure 12-9 a).
b). Click
Send
(See Figure 12-9 b) to
program the Coin Changer or
Cancel
(See Figure 12-9 c) to return to the
mode menu.
8. Configuring Changer tube “Coin Sorting”.
a). Select
Coin sorting
…
from the
mode menu.
b). The screen
shows the current tube configuration
(See Figure 12-10).
c). To change the tube configuration, select
Change
(b) and then select from the
available payout combinations listed.
d). Click
OK
(c) to select or
e).
Back
to reset to Step “b” and then
f).
Send
to program the Coin Changer.
9. Enabling the Bill Recycler.
a). Select the
Recycler
…
tab on the
menu screen and then check the
5
Recycler active
tick box to enable the
RC-10 recycling unit (See Figure 12-11).
The recycle value will be set by the Coin
Changer’s software.
Figure 12-8 Float up Selection Warning
If “Float up function on” is enabled and
the level settings are not configured (i.e.,
set to zero [0]), the tube float level will
only fill to the 50% sensor level.
b
a
c
Figure 12-9 Security Stock Mode
NOTE: A “Security Stock” level of three
(3) coins is recommended to prevent
“coin bounce” and possible stacking
issues in the Coin Changer tubes.
Figure 12-10 Coin Sorting Mode
e
c
b
d