5900335 © 2005 JCM-American Corporation
12-2
Section 12 Optipay™ CC PALM PILOT® USAGE
4. Set functions listed in
Figure 12-5 “a” through “h”.
a).
Inventory
check box functions are:
•
Blocked
– Inventory keypad is disabled
•
Enabled by machine control
–
Inventory keypad can be enabled by the
Vending Machine. This requires a
service pass code
•
Enabled
– Inventory keypad enabled
b).
Payout security stock allowed
– Check
to enable the machine to pay the entire
contents of the change tubes.
c).
Accumulate credit
– Low value coins are
inserted until a credit value is reached. The
Coin Changer then sends the value to the
VMC.
d).
Float up function on
– Enable to allow
float up levels. Coin “float” values are set
on the “Coin Settings” page.
e).
With high string protection
– Enabling
high string protection will cause the Coin
Changer to send the next 100 coins to the
cashbox if the string sensor is triggered.
f).
Tube Counter with security stock
–
Check Tube Counter’s security stock,
including the security stock values, to
transmit tube contents to the VMC.
g).
No correction of tube counters
– to
disable the automatic Coin Changer Coin
Tube Sensors.
m).
“Tube empty” function for bills
–
Check this function to disable acceptance
of high value bills when the Coin Changer
is empty.
5. Select
Inhibit Mask…
on the screen
to enable or disable coin/bill acceptance
(See Figure 12-6 a).
a). Select the tick box next to each denomin-
ation that is to be disabled (See Figure 12-
6 b).
b). Select
Send
to program the Coin
Changer or
Cancel
to return to the
screen (See Figure 12-6 c).
6. Setting the Changer’s “Float Level”.
a). Configure the “Float Level” for each coin
denomination by using the triangular “up”
and “down” pointing arrows on the
screen (See Figure 12-7 a).
b). Click
Send
to program the Coin Changer
(See Figure 12-7 b).
Select the desired settings and click Send
(See Figure 12-5 i)
to program the Coin
Changer or
Cancel
(See Figure 12-5 j)
to
return to the
Settings
screen.
Figure 12-5 Operating Modes
a
b
c
d
e
f
g
h
i
j
b
c
a
Figure 12-6 Inhibit Coin Channels Mode
a
b
Figure 12-7 Float Level Mode
