Filter
Top Products
5900335 © 2005 JCM-American Corporation
2-1
Optipay
™
CC
A-66 Coin Changer
Section 2
2 SAFETY INSTRUCTIONS
This section providessafety instructions for using
the Optipay™ CC A-66 Coin Changer.
Before operating the device for the first time,
please carefully read through this manual at least
once, and most importantly, read the safety instruc-
tions. This ensures that the contents of this manual
and the operation of the A-66 Coin Changer is
completely understood.
Proper use
The four tube A-66 Coin Changer is intended for
use in vending and service machines containing the
serial MDB interface. Only use the A-66 Coin
Changer for this purpose. Under no circumstances
can the manufacturer be held liable for any damage
or loss resulting from improper use of the device.
The Coin Changer series is state of the art and has
been constructed in compliance with recognized
safety regulations. Nevertheless, this equipment
can be a source of danger. Therefore, please
observe the following safety regulations:
Protecting Yourself and the Equip-
ment
The A-66 Coin Changer may only be
connected by a qualified electrician/
electronics technician.
Only use the Coin Changer according to
for it’s intended use. Under no
circumstances can the manufacturer be
held liable for any damage or loss
resulting from improper use of this
device.
The Coin Validator‘s printed circuit
board (pcb) is fitted with electronic
components which may be damaged
beyond repair by electrostatic
discharge.
Please observe the handling
instructions regarding static sensitive
components.
Select the correct operating voltage for
the Coin Changer (see device label
directly, or Figure 3-4 in section 3).
Never pull on the Coin Validator’s Coin
Changer connecting cable when a
voltage is applied!
Remove the Vending Machine’s Power
Line Plug before you install, clean or
remove the Coin Changer.
Always transport the Coin Changer
empty of coins and in its original
packaging. It is sufficiently protected in
this way. Never carry the Coin Changer
by its external cables.
Contact JCM if you wish to alter the Coin
Changer’s design greater than that
which is described in these instructions.
Keep water and other liquids away from
the Coin Changer.
Dispose of a damaged Coin Changer
correctly, if you have no further use for
it.
JCM reserves the right to make
technical modifications to the device
which are not covered by these
instructions.