Audiovox GX2411ci Cordless Telephone User Manual


 
GX2411ci English I/B ver. 09010A-1
21 09010A-1
OWNER
S MAN #
GX2411ci
VER. 09010A-1
PAGE: 21 English version
NOTE:
If memory is full, the unit will announce
“ Memory full.”
and Two-Way recording is
not possible. You can erase any or all the messages remotely after listening to them. Refer
to the REMOTE OPERATION section for more details.
Recording two-way conversations may be subjected to Local State and Federal laws and
regulations
VOX (VOICE ACTIVATED) DETECTION
During ICM recording, the GX2411CI uses
VOX (voice activation) to conserve message
storage space. The conditions for the GX2411CI terminating a recording are:
Continuous silence for seven seconds.
Seven seconds after the caller hangs up.
REMOTE OPERATION
Allows you to access most of the GX2411CI functions away from the base unit using only
the handset or any touch tone phone when you call the GX2411CI. You can play, review,
repeat, skip, erase, and stop messages in the message boxes, record a Memo or an OGM,
set the Answer Mode ON or OFF, change your password, set the time and day, activate
the call screening function and the Voice Menu.
USING THE REMOTE OPERATION FUNCTION
There are Two-Ways of using Remote Operation:
1.
Handset (Remote Unit), or
2.
Calling the GX2411CI from a Tone Dialing Phone
A. USING THE HANDSET
1.
Press the REMOTE button to activate the remote
function.
2.
The handset and base unit IN USE LED indicator will blink. (Figure 28)
B. CALLING THE GX2411CI FROM A TONE PHONE
NOTE :
The factory preset password for remote operation is
“#58”.
1. Call the GX2411CI from a tone dialing phone.
2. While the OGM is playing or during ICM recording, enter # plus your 2 digits
password.
3. After a successful password entry, the Remote Operation function is on.
Once you have activated the Remote Operation function either by handset or through a
tone dialing phone to call the GX2411CI:
1. The GX2411CI will announce the total number of new message(s) in Message (MSG)
box.
2. The unit will prompt
“For help, press 9
.”
REMOTE COMMANDS
A. VOICE HELP MENU
Press
9
for Voice Help Menu. All remote commands can be entered during playback of the
menu. The following table shows the Voice Help Menu:
Key
Function
1 Change Password
2 Change Time and Day
3 Playback Memo Message
4 Record Memo Message
5 Record OGM Message
6 Set Answer Mode to ON
7 Playback Message (ICM or Two-Way Recording)
8 Playback OGM