Filter
Top Products
94
Appendix
My telephone
system does not
work at all.
• Make sure the handset battery is installed and charged correctly (see
page 14). For optimum daily performance, return the cordless handset
to the telephone base after use.
• Make sure the power adapter is securely plugged into an outlet not
controlled by a wall switch.
• Make sure the telephone line cord is plugged firmly into the telephone
base and the modular wall jack.
• Reset the telephone base. Unplug the unit’s electrical power. Wait for
approximately 15 seconds, then plug it back in. Allow up to one minute
for the cordless handset and base to reset.
• Remove and re-insert the battery pack. If that still does not work, it may
be necessary to purchase a new battery pack.
• First, try all the above suggestions.
• Move the cordless handset closer to the telephone base. It might be out
of range.
• The telephone line cord might be malfunctioning. Try installing a new
telephone line cord.
• Disconnect the telephone base from the telephone jack and connect a
different telephone. If there is no dial tone on the telephone either, the
problem is in your wiring or local service. Contact your local telephone
company.
There is no dial
tone.
I cannot hear
any audio on
my telephone
system when
on a CELLULAR
call.
• Reset the telephone base. Unplug the unit’s electrical power. Wait for
approximately 15 seconds, then plug it back in.
• Turn off your cell phone, then turn it on again.
The PIN on the
telephone base
does not work.
• The default PIN is 0000.
• If you change the PIN on the telephone base, it will appear on the
telephone base display in the pairing process.
Bluetooth
System Busy
appears on the
display.
• Make sure that your cellular phone is in idle mode when connected and
on the Active Devices list.
• Make sure that your cellular phone or headset is not connected to any
other Bluetooth device.
• The EP5632/EP5632-2 can only use one Bluetooth device at a time.