Filter
Top Products
6
Getting started
Telephone base and charger installation
Install the telephone base and charger as shown below.
The telephone base is ready for tabletop use. If you want to change to wall
mounting, see Installation options on page 9 for details.
Telephone base installation
Charger installation
IMPORTANT INFORMATION:
Use only the power adapter(s) provided with this
product. To obtain a replacement, visit our website at
www.telephones.att.com or call
1 (800) 222-3111. In Canada, dial
1 (866) 288-4268.
The power adapters are intended to be correctly oriented
in a vertical or floor mount position. The prongs are not
designed to hold the plug in place if it is plugged into a
ceiling, under-the-table or cabinet outlet.
•
•
Plug the power adapter into an electrical outlet not
controlled by a wall switch.
Plug the small end of the telephone base power adapter into
the power adapter jack on the back of the telephone base.
Raise the antenna.
Route the power adapter
cord through this slot.
Route the telephone line
cord through this slot.
Plug the other end of the
telephone line cord into the
telephone jack on the back
of the telephone base.
If you have DSL high-speed
Internet service, a DSL filter
(not included) is required.
The DSL filter must be plugged
into the telephone wall jack.
Plug the large end
of the telephone
base power adapter
into a power outlet
not controlled by a
wall switch.
Plug one end of the
telephone line cord into a
telephone jack or a DSL filter.