Filter
Top Products
DIRECT CONNECTION
To connect your voice terminal locations directly to the control unit, do this:
1
4
2
3
10
1
2
3
4
5
6
In the system directory, fill in the voice terminal location you have
selected for each intercom number.
Beginning with the pair of labels marked 0 for Model 206 or 10 for Model
410, label each cord at both ends with matching labels.
TIP: If the distance between a voice terminal location and the control
unit requires the use of extension cords, label each end of the wiring
run. Attach one label near the plug to the voice terminal and the
matching label near the plug to the control unit.
Run the cords from the voice terminal locations to the control unit.
CAUTION: Do not run cords inside or on top of air plenums or
ducts, along hot pipes, or across walkways. If you use staples to
attach cords to walls or baseboards, be careful not to pierce the
cords.
Plug each cord into the voice terminal jack on the control unit with the
same number as the cord label.
Peel the backing off the system directory, and attach the directory to
the inside of the control unit’s door.
Fit the door onto the control unit.
Wiring run to intercom 10 location
14