AT&T 1080 Telephone User Manual


 
66
Answering system operation
DTAD setup
ANSWER DELAY
Set the length of time this phone rings before the
answering system picks up the call. One ring cycle
lasts about six seconds.
1. Press [ENTER].
2. Press [ ] or [ ] until you see DTAD SETUP. Press
[ENTER].
3. Press [ ] or [ ] until you see ANSWER DELAY.
4. Press [ ] or [ ] to choose the desired setting
(12–40 seconds).
5. To move to the next feature, press [ ].
-OR-
To exit setup, press and hold [ENTER].
TOLL SAVER
When toll saver is turned on, the answering system
picks up incoming calls within eleven seconds if
there are any new private messages. When there
are no new messages, the answering system picks
up the incoming call in the time you set as the
answer delay. (See ANSWER DELAY section above
on this page for details).
To turn toll saver on or off:
1. Press [ENTER].
2. Press [ ] or [ ] until you see DTAD SETUP. Press
[ENTER].
3. Press [ ] or [ ] until you see TOLL SAVER.
4. Press [ ] or [ ] to choose ON or OFF.
5. To move to the next feature, press [ ].
-OR-
To exit setup, press and hold [ENTER].
DTAD SETUP
15 SEC
ANSWER DELAY
DTAD SETUP
ON
TOLL SAVER
NOTE: For the auto
attendant to work
properly, you must
make sure that the
DTAD answer delay
time is longer than the
auto attendant answer
delay time (page 58 of
the installation guide).
NOTE: If the toll
saver feature is ON,
for the auto attendant
to work properly, you
must make sure that
the auto-attendant
delay time (page 49
of the installation
guide) is shorter than
11 seconds.