Filter
Top Products
9
The Wall Mount adaptor is designed to
fit on standard Wall Mount plates.
1. Choose a spot near an electrical
outlet and a telephone jack. Your
phone requires a modular tele-
phone jack and a standard electri-
cal outlet (120V AC). The power
cord is six feet long; make sure there
is an electrical outlet within reach
of the Base. The outlet should not
be controlled by a wall switch. If the
switch is ever turned off, the phone
will not operate.
2. Position the wall mount adapter
on the Base. Line up the tabs on
the wall mount adapter with the
holes on the bottom of the Base.
Snap the wall mount adapter firmly
in place.
3. Mount the Base on the wall. Posi-
tion the Base so the mounting studs
will fit into the holes on the bottom
of the Base. Position the power cord
to extend down the wall the phone
is to be mounted on. Slide the Base
down on the mounting studs until it
locks into place.
4. Connect the telephone cord(s).
The telephone line cord has a
snap-in plug at each end. Insert one
of the plugs into the jack(s) on the
bottom of the Base. Insert the other
end of the plug into the wall jack(s).
5. Connect the power cord. Plug the
DC connector into the DC jack at
the rear of the Base Unit. Plug the
AC power adaptor into an electri-
cal outlet.
WALL MOUNTING
wallboard
wooden
stud
DIAL MODE
PULSE
TONE