VTech VT 9241 Cordless Telephone User Manual


 
18
press INT.COM/PAGE on the Base
to page the Handset. Then press
INT.COM on the Handset to enter
Intercom mode.
3. To end the Intercom conversation,
press OFF on either the Handset or
OFF on the Base Unit.
4. To return to the call, press the ap-
propriate LINE key on the Handset
or Base.
TEMPORARY TONE FEATURE
If you have rotary (dial-pulse) tele-
phone service, (TONE/PULSE switch
is set to PULSE), this feature allows you
to enter special codes and tones to
operate answering machines, use elec-
tronic banking services, calling cards,
or other special services.
To do this:
1. Dial the call normally.
2. Activate the temporary tone feature
by pressing TONE (the key).
3. Press the numbers or symbols you
need, and your phone will send the
proper signals.
This feature is available on both the
Handset and the Base Unit.
To end the call, press OFF . The phone
will automatically go back to rotary
(dial-pulse) service.
PROGRAMMING THE RINGER TYPE
The VT 9241 features four different
Handset ringer types for each line.
To return to the phone call, press the
appropriate LINE key on Base or Hand-
set.
IF YOUR PHONE RINGS DURING AN
INTERCOM CONVERSATION
If you receive a call while using the In-
tercom, the Base will only ring once,
and the Handset will generate 3 alert-
ing tones through the earpiece. The
LINE key will flash on both Base and
Handset. You can answer the incom-
ing call by pressing the LINE key of the
ringing line on the Base or Handset.
However, by answering the incoming
call you will automatically exit the In-
tercom mode.
USING THE INTERCOM DURING A
PHONE CALL
The HOLD feature allows you to put a
phone call on hold and use the Inter-
com without disconnecting your caller.
It works at the Handset or the Base.
1. While you are on the call on the
Handset, press the INT.COM key to
automatically place the active call
on hold, and to establish an Inter-
com call between the Handset and
Base.
2. While you are on the call on the
Base Unit, press HOLD and then
OPERATING INSTRUCTIONS
*
TONE
0
OPER
HOLD CHAN INT.COM
PGM CONF REDIAL
PAUSE
MEM